INSTALLING VERSATEX PROPRIETARY PRODUCTS

Soffit System

Soffit comes in solid or vented. The vented has an 1/8” wide groove to minimize insect infiltration.
The Vented Soffit features 10” of free airspace per linear foot.
Vents can be screened if required by code.
The Notched Fascia requires no flashing or cover.
Notched Fascia has 9/16” plowed pocket to accept soffit.
Frieze Boards which are plowed with a 9/16” pocket to neatly accept the half inch thick soffit.

Miter soffit at corners rather than butting soffit at corners. Use a “T” mould at joints rather than sealants or adhesives.
Make sure the soffit panel is fully engaged into the plowed slot on the fascia board.
Building the soffit system on the ground and installing it as one piece is not recommended. The soffit overhang is not going to be a perfect 90 degree angle, so it is best the three components be installed individually so they properly conform to the walls of the building.
Bond the soffit panel to the fascia pocket with TrimWelder slow cure adhesives by Extreme Adhesives.
In a rake application, be sure the edge angle on the soffit panel is cut to the same slope as the roof where two soffit panels abut.